Specifications
Sanding plate maximum width | R-RP630mm | R-RP1000mm | R-RP1300mm |
Sanding plate thickness | 2.5-110mm | 2.5-110mm | 25-110mm |
Sanding plate length | >200mm | >200mm | >200mm |
Belt speed (first group) | 20m/s | 20m/s | 19.5m/s |
Belt speed (second group) | 16m/s | 16m/s | 15m/s |
Belt size (width * length) | 640*1900 | 1020*2000 | 1330*2200 |
Total motor power | 22kw | 28kw | 64kw |
First sand motor power | 11kw | 15kw | 37kw |
Second sand motor power | 7.5kw | 11kw | 22kw |
Conveyor motor power | 1.5kw | 1.5kw | 4kw |
Workbench lifting motor power | 0.37kw | 0.37kw | 0.37kw |
Feed rate | 5.5-28m/min | 5.5-28m/min | 55-28mmin |
Dimensions (width * length * height) | 1200*2000*1930 | 1570*2000*1930 | 2450*2700*2100 |
Equipment weight | 2000kg | 2800kg | 3500kg |
STILL WORRIED ABOUT PROCESSING?
LOW MANUAL EFFICIENCY
IRREGULAR SANDING IS NOT FINE ENOUGH
MANUAL SANDING IS TOO STRONG
More than one detail,brilliant
lmported bearing
The bearing imported from Japan for sanding machine can accelerate
the working efficiency and prolong the service life of the machine.
TWO rollers and one pad structure
Use regular thickness sanding and fin esanding with various boards.
Water—oiI separator
Effectively filter the moisture in the air and extend the service
life Of pneumaticc omponents.
Rubber material conveyor beltr
Long time use will notappear off—tracking situation,aggravate the
fuselage to prevent shaking waves,to prevent deformation.
Cast iron gearbox transmission motor
Even in the case of high temperature,it does not affect the
work.Conveying speed can be adjusted atwill.
For more details
The whole film
X. Lubrication and maintenance of machine tools
—- after each shift
(1) Clean the entire machine, and the surface of the feeding workbench and the surface of the sanding roller should be free of dust.
(2) Check the compressed air filter to remove the condensation.
—-After work every week
(1) Lubricate the lubrication points of the machine according to the lubrication requirements in the table.
(2) Check the air venting device to remove the condensate.
(3) Check the sanded graphite cloth and replace it if necessary.
—-After monthly work
(1) Lubricate the lubrication points of the machine according to the lubrication requirements in the table.
(2) Check the tension of the machine feed drive and the lift drive bar, and tension if necessary.